What are commands?
A command is a function that executes a pre-programmed action.
It is used to execute a specific action one-off.
Example: "Move the arm", "Move the lifter", "Speak", etc.
Commands are set within each "mode" in the "Command List".
To execute a command, select the mode you want to use and then click the command set for that mode.
How to execute commands
Before operating ugo, please read [⚠Please read before operating ugo]
Command List: Select Mode
①Click the pull-down list to the left of "Command: Mode" in the upper right corner of the ugo operation screen.
②The command list modes are displayed.
Click to select the mode you want to use.
Executing commands
③Click the pull-down list to the right of "Command: Mode" in the upper right corner of the ugo operation screen.
④A list of commands set for the selected mode will be displayed.
Click on the command you want to run to execute it.